Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rubber mounts hold the transmission in place.
These rubber mounts hold the transmission in place. Check your old mounts while the transmission is in the car. To check the rear mounts, take a pry bar and place it between the saddle and bellhousing and pry up. If the transmission moves, the rear mounts are bad. To check the front mount, place the pry bar between one of the forks and the transmission and pry up. If the nose of the transmission moves, replace the front mount. Stick shift movement on acceleration and deceleration are symptoms of a broken front mount. Note: Don't use solid mounts on the street. The noise that's transmitted through the tunnel will drive you crazy.
Bug (Type 1): 66-72
Type 3: 66-67
Ghia: 66-72
Thing: 73-74
Off-Road: 66-72
No customer reviews for the moment.
Part #: 111301207
Nose Cone Bushing, Front or Rear, Early
Application:Part #: 111301289
Nose Cone Boot
Application:Part #: 113311113A
This seal goes around the mainshaft.
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 211301265AFA
Transmission mount, front, mid
Application:Part #: 111301289B
This boot goes around the nose cone to seal up the hole where it comes through the pan.
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:Part #: 113301264
These rubber mounts hold the transmission in place.
Application:Part #: 113301263C
These rubber mounts hold the transmission in place.
Application:Part #: 113301189F
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 113517191
Swing Axle Fulcrum Plates
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 1301150
Bolt on Center Transmission mount, Urethane stops included
Application:Part #: 111398003
Transmission gasket set.
Application:Bug (Type 1); -60
Bus (Type 2); -59
Ghia; -60
Part #: 211301205H
This is the front of the transmission that houses the shift lever.
Application:
These rubber mounts hold the transmission in place.
