Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This kit eliminates the clips and spring washers in a rocker shaft set up.
This kit eliminates the clips and spring washers in a rocker shaft set up. It's a must on engines running heavy duty springs and big cams. We recommend using solid shaft rockers on any engine with a larger cam. Note: Proper shimming, as well as the geometry setup are very important.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1109430
These shims are used under the rockers to set the geometry.
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109611
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: 113109309C
These ride against the cam. Sold each. You will need 8 to do an engine
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109403
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113109601D
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: 1109335
These stock-style tubes are made of stainless steel.
Application:Part #: 1109339
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 113109021DBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 1109623
These are single heavy duty valve springs which are used on engines with Engle 110 or larger cams.
Application:
This kit eliminates the clips and spring washers in a rocker shaft set up.
