Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This pulley on the end of the crank turns the fan belt.
This pulley on the end of the crank turns the fan belt. It's also used for timing and adjusting your valves. We highly suggest using a stock-size pulley, as a smaller pulley will turn the fan slower. The main reason for replacing a pulley is that your old one is bent. Note: To make the pulley slide on easier, put a little white grease on the inside of it where it slides on the crank.
Bug (Type 1): 66-79
Bus (Type 2): 66-71
Ghia: 66-74
Thing: 73-74
Race/Off-Road: 66-79
No customer reviews for the moment.
Part #: 1105259
This is a chrome stock bolt and washer that holds the crankshaft pulley on.
Application:Part #: 311105401BRC
Most people don't realize that these are one of the most important parts in the motor.
Application:Part #: 111105271CO
Core
Application:Part #: 1105271
If your are going to run a 69mm or a 78 mm counterweighted crank, then you will want to have your flywheel 8 doweled or get a flywheel has been 8 doweled.
Application:Part #: 1105253RD
This is a crank pulley for an upright motor.
Application:Part #: 1105305
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 1105254BK
This is a crank pulley for an upright motor.
Application:Part #: 1105251ALRD
Aluminum Stock Crankshaft Pulley Red
Application:Part #: 111105223
This brass gear goes on the crank to turn the distributor drive shaft.
Application:Part #: 1105178
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:Part #: 1105402
I-Beam Rod, 5.500", VW Journal 2.165"/55mm (EMPI 3/8" Rod Bolts), Set of 4
Application:Part #: 1105273CH
Lightened 12 lb.
Application:Part #: 311105273AN
VW Flywheel, 200mm 12 volt 15-1600cc Engines
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 111105245
This seal goes behind the flywheel.
Application:Part #: 113105701
These are the shells that go in the rods and ride on the crank.
Application: