Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
If you have high compression you will need to vent the valve covers into a breather box. These are the fittings you will need for the stock valve covers. We suggest that after you bolt these into your covers, use 3M glue to seal them.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 1198092ACH
92mm Pistons & Cylinders set with a 69mm Stroke CHINA
Application:Part #: 1101477BL
These covers look good but have a tendency to leak.
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 1198090A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 021101457
These nuts and washers hold the heads on.
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1101353
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109602
Valve seats are used in the big valve heads.
Application:Part #: 070198169
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 1101354
Whether your motor lives or not can depend upon this little shim.
Application:
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
