Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These nuts and washers hold the heads on.
These nuts and washers hold the heads on. The washers are thick so they won't deform under heat and torque. The torque on 10mm nuts is 28 ft. lb. and the 8mm nuts is 18 ft.lb. One trick is to use 3M glue on the bottom of the washers in the rocker area to prevent leaking through the head.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1101346
36 HP Barrel Shims .060 (4)
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1107434
Not our favorite type of piston pin keeps.
Application:Part #: 1198159B
These rings are cast iron.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 070198169
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101442
This is a shim that is used between the head and barrel.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 311101353A
New single port head.
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 1101476
These are great valve covers.
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 1198160B
These rings are cast iron.
Application:
These nuts and washers hold the heads on.
