Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This gasket goes between the valve cover and the head.
This gasket goes between the valve cover and the head. We usually put them on dry. If they leak, use a sealer called Gasgacinch on the valve cover side of the gasket only and just under the bottom of the head side. If they still leak, replace the valve cover bail and maybe even the cover itself. Never use 3M glue on these unless you never, ever plan to get them off again.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1107435
Not our favorite type of piston pin keeps.
Application:Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101374
40 HP Barrel Shims .040 (4)
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 1198090ACH
90.5mm Pistons & Cylinders - 69mm Stroke CHINA
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101391
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1101441
This is a shim that is used between the head and barrel.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:
This gasket goes between the valve cover and the head.
