Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim.
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call or go to our tips and find the article I wrote on it. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
No customer reviews for the moment.
Part #: 1107435
Not our favorite type of piston pin keeps.
Application:Part #: 1198162TS
92mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 113101355A
New dual port head
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198162
These rings are cast iron.
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101393
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101352
.
Application:Part #: 1101355
Here's another long subject, but it'll give you a little something to think about.
Application:Part #: 1101351
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 311198169B92
Piston Ring Set 92mm
Application:Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 1101446
This is a shim that is used between the head and barrel.
Application:
Whether your motor lives or not can depend upon this little shim.