Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are great valve covers.
These are great valve covers. They're deep enough to accommodate most style rockers. They have a channel style gasket that can be reused. The only problem we've seen is that people tend to over tighten the cover and and that rips the gasket. We run the bolt down until it just hits the cover, then one more turn with the wrench.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 1101353
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101440
This is a shim that is used between the head and barrel.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1101383
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111198157BBB
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198094B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 1101442
This is a shim that is used between the head and barrel.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:
These are great valve covers.
