Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim.
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call or go to our tips and find the article I wrote on it. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
No customer reviews for the moment.
Part #: 1101381
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198163A
These rings are cast iron.
Application:Part #: 1101355
Here's another long subject, but it'll give you a little something to think about.
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 111198057A
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1198090B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1198094C
94mm Mahle Barrels
Application:Part #: 1198160B
These rings are cast iron.
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:
Whether your motor lives or not can depend upon this little shim.