Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. We do not like the wire type of wrist pin keepers and suggest you buy a set of Tru-Arc type keepers. When you get pistons and cylinders, the pistons need to be taken out of the cylinders and have the cosmoline cleaned off and the ring gaps set. Note: The arrows on the pistons go towards the flywheel. If you want your motor to last, I suggest you flip ahead and read BARREL SHIMS.
Bus (Type 2): 1700
No customer reviews for the moment.
Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 315198163A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: 1101381
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113101355A
New dual port head
Application:Part #: 1101462KIT
This kit has the correct nuts and washers to hold the heads on the engine..
Application:Part #: N110071
Some of the more common nuts you might need..
Application:Part #: 111198157BBB
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: N122343
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 021101487
Valve Cover Retaining Clip
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
