Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:These springs return the valves back to their seats.
These springs return the valves back to their seats. You can use your old springs, but make sure that you check them with a spring gauge to see if they still have the same tension. Heavy duty springs are recommended for high RPMs and steep cams. Dual springs are for the race tracks, not the street.
Bus (Type 2): 78-79
Vanagon: 80-83
No customer reviews for the moment.
Part #: 1198090B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 113101475B
These are good bolt on valve covers. Black in Color
Application:Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101391
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 021198175A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1101468
If you have high compression you will need to vent the valve covers into a breather box.
Application:Part #: 022198075ACH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101469
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198090A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application: