Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These bolt on valve covers are for the pancake style engine.
These bolt on valve covers are for the pancake style engine. They use the stock valve cover gaskets. The trick of tightening them is to run the bolts down until the washers touch the cover and then make one more full turn.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198090A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1198160B
These rings are cast iron.
Application:Part #: 022101361C
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 021198175A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 2101304
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 022198075ACH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:
These bolt on valve covers are for the pancake style engine.
