Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Bad guides are replaced and new exhaust valves are installed along with a three angle valve job. All heads are bead blasted and measured for cc volume. Flycutting is done if needed. Note: It is better to buy these in pairs so we can match up a pair by cc's. The amount of cc's greatly affects the compression ratio. We do not believe in head shims, but recommend barrel shims to lower the compression ratio. CORES FOR REBUILT HEADS MUST NOT HAVE CRACKS OR WELDS.
Bug (Type 1): 1300
Bus (Type 2): 1300
Type 3: 1300
Ghia: 1300
No customer reviews for the moment.
Part #: 1107435
Not our favorite type of piston pin keeps.
Application:Part #: 070198169
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 311198169B92
Piston Ring Set 92mm
Application:Part #: 1101381
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101357
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101354
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101382
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101442
This is a shim that is used between the head and barrel.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 1109604
Valve seats are used in the big valve heads.
Application:Part #: 1101392
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198163
These rings are cast iron.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
