Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All kits come with pistons, cylinders, rings, wrist pins and clips.
All kits come with pistons, cylinders, rings, wrist pins and clips. Many of the kits will require machine work to the heads and case. Before you buy a kit, you should have a good understanding of how to set the compression ratio. Many people think that bigger motors are unreliable. This is just not true. When a motor is properly designed and built, it can be very dependable. You will not realize the full potential of the bigger pistons, unless you run big valve heads. There is a lot of information needed, so call us and we will gladly help. Note: The only thing we don't like about these kits are the rings and the wrist pin clips.
No customer reviews for the moment.
Part #: 1198094BCH
94mm Pistons & Cylinders set with a 82mm Stroke CHINA
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1198161
These rings are cast iron.
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 1101468
If you have high compression you will need to vent the valve covers into a breather box.
Application:Part #: 1101469
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 1101442
This is a shim that is used between the head and barrel.
Application:Part #: 1198163A
These rings are cast iron.
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:
All kits come with pistons, cylinders, rings, wrist pins and clips.
