Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud. The doghouse shroud had the oil cooler ducting on the back and came on the 1971 Bus or 1971 and later Bug, Ghia, or Thing. The nice thing, about this smaller shroud, is it gives you more room around dual carburetors. It also has better cooling then pre 1970 fan shrouds.
Bug (Type 1): 1600
Bus (Type 2): 1600
Ghia: 1600
Thing:1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 1119302CH
These cylinder head tins sit under the fan shroud.
Application:Part #: 043119350B
Heater Channel Tin Upper Right
Application:Part #: 131119358
These are the short pieces that fit under the big cylinder tin towards the crank pulley.
Application:Part #: 1119100
These plugs fit into the fan shroud, plugging off the heater ducts.
Application:Part #: 1119431BK
These are the two pieces of tin that attach to a doghouse style fan shroud.
Application:Part #: 113119031B
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: 043119351B
Heater Channel Tin Left
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 113119317
These are also known as the "forget-me-nots".
Application:Part #: 1119027CH
This small fan shroud came on the 36hp motor.
Application:Part #: 311119317A
These are also known as the "forget-me-nots".
Application:Part #: 1119527BK
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119025CH
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 1119533BK
This tin goes behind the crank pulley.
Application:Part #: 1119317CH
Cool tins are must for those of you with high performance exhaust systems without heater boxes.
Application:Part #: 1903031CH
This is one of the three-pieces of the Alternator or Generator Tin Set, it's the large flat plate that is seen.
Application: