Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These mounts should only be used on cars that are not daily drivers.
These mounts should only be used on cars that are not daily drivers. The good thing about them is the trans doesn't move. The bad thing is they are hard on parts and transmit a lot of noise into the car.
Race/Off-Road: 61-72
No customer reviews for the moment.
Part #: 1301265
These mounts made of urethane never wear-out.
Application:Part #: 1301263
These mounts made of urethane never wear-out.
Application:Part #: 1301185
This heavy duty side plate keeps the ring and pinion where it's supposed to be.
Application:Part #: 6301265
Putting a Bus IRS trans into your bug is the way to go, because it comes with a lower ring and pinion stock and is a stronger trans.
Application:Part #: 1301184
This heavy duty side plate keeps the ring and pinion where it's supposed to be.
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:Part #: 6301150A
Type 2 Transmission Center Mount Only
Application:Part #: 311301265B
These rubber mounts hold the transmission in place.
Application:Part #: 6301267
Front Transmission Solid Mount with Hardware
Application:Part #: 6301266
These mounts should only be used on cars that are not daily drivers.
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 001301209A
Nose Cone Seal Holder
Application:Part #: 1301147
Solid Trans Mid Mount
Application:Part #: 6301150
Type 2 Transmission Mount Kit, Weld in Front mount Brackets For Tube Chassis Only not Stock Framehorns
Application:Part #: 111301289B
This boot goes around the nose cone to seal up the hole where it comes through the pan.
Application:Part #: 113517191
Swing Axle Fulcrum Plates
Application:
These mounts should only be used on cars that are not daily drivers.
