Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These cranks are made from stock German core cranks.
These cranks are made from stock German core cranks. This is the way to go if you plan to rev your engine past 5K RPMs. The crank comes 8 doweled and both main journals have been ground. A core is required. We like this crank better than the new ones out there. We have found the new counter weighted cranks require a lot of machine work to get them to clear in the case.
No customer reviews for the moment.
Part #: 111105271CO
Core
Application:Part #: 1105257
This is a billet, zinc plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 113105219
Crankshaft Spacer Ring
Application:Part #: 111105285
Flywheel Shim 25-36HP, .32mm (0.0125")
Application:Part #: 111105433
Wrist Pin Bushing.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
KG; 40hp
Part #: 113105209
This is a steel gear that goes on the crank to turn the cam.
Application:Part #: 1105277
Here are some flywheel pins that give you more contact surface on the flywheel.
Application:Part #: 1105251CH
This is a stock pulley that has been chromed.
Application:Part #: 111105701A
These are the shells that go in the rods and ride on the crank.
Application:Part #: 1105251ALBL
Aluminum Stock Crankshaft Pulley Blue
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105271
If your are going to run a 69mm or a 78 mm counterweighted crank, then you will want to have your flywheel 8 doweled or get a flywheel has been 8 doweled.
Application:Part #: 1903108RD
EMPI Serpentine Belt System Red
Application:Part #: 1105219
This spacer goes between the steel cam gear and the brass distributor gear on the crank.
Application:Part #: 1105259
This is a chrome stock bolt and washer that holds the crankshaft pulley on.
Application:Part #: 311105295A
This seal goes in the flywheel.
Application:
These cranks are made from stock German core cranks.
