Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:These are used cranks with reground rod and main journals.
These are used cranks with reground rod and main journals. Each crank is checked for cracks and wallowed out dowel pin holes. We only grind to 10 under, 20 under and 30 under; any further and the bearings are getting too thick. We also grind on the high side of the scale to insure maximum life out of the crank. A 10 under crank will read 2.155; a 20/2.145, and a 30/2.135. If you mic a used crank and the last number is below a 4, then you shouldn't run it. Example: The reading you get is 2.15382. This is a worn out 10 under crank and should be turned in for a 20 under. All cranks are sold on an exchange basis, cores must be usable.
No customer reviews for the moment.
Part #: 113105241A
This is a large concave washer that goes on the crank after you have the nose bearing on.
Application:Part #: 1105401A
These connecting rods are longer than stock.
Application:Part #: 1105251ALBL
Aluminum Stock Crankshaft Pulley Blue
Application:Part #: 1105182
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:Part #: 1903108PL
EMPI Serpentine Belt System
Application:Part #: 111105401EMP
New Connecting Rods, 13-1600cc, Set of 4
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105305R
This is a large thrust surfaced gland nut made out of chromoly.
Application:Part #: 1105258
This is a stock, zinc-plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 1105251ALRD
Aluminum Stock Crankshaft Pulley Red
Application:Part #: 1105253RD
This is a crank pulley for an upright motor.
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105251CH
This is a stock pulley that has been chromed.
Application:Part #: 111105313A
It's really a bolt, but that's what everybody calls it.
Application:Part #: 111105713A
Rod Bearings .20
Application:Part #: JC86070
Jaycee Billet 7" Crank Pulley for Street Cars, Silver
Application: