Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These fittings are used for the stainless steel hose.
These fittings are used for the stainless steel hose. Keep in mind there will be two fittings per connection. On the pipe thread end use teflon tape and don't "muscle" them. Turn them as tight as you can by hand, then one more full turn with a wrench.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 113117303
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 1115349
This plate will block off the type 3 oil filler hole in a universal case.
Application:Part #: JC22260
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Black
Application:Part #: 111115487
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 1115193
This plug for the bottom of the sump plate has a magnet in it.
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 1117699
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1115183RD
This plate is made out of a solid piece of aluminum. Red
Application:Part #: 1117012
These bolt on mounts allow you to bolt the filter adapter under the driver's side fender or hang it off the exhaust flange..
Application:Part #: 1117024
Mesa coolers are the state of the art oil coolers.
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1115351BUL
This is the last oil filter you will ever buy.
Application:Part #: 113115193
This is the bolt that goes in the plate on the bottom of the motor.
Application:Part #: 1117100
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111115475A
Oil Filler Seal, 25-36 HP
Application:Part #: 1117022
Mesa coolers are the state of the art oil coolers.
Application:
These fittings are used for the stainless steel hose.
