Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This gasket goes between the valve cover and the head.
This gasket goes between the valve cover and the head. We usually put them on dry. If they leak, use a sealer called Gasgacinch on the valve cover side of the gasket only and just under the bottom of the head side. If they still leak, replace the valve cover bail and maybe even the cover itself. Never use 3M glue on these unless you never, ever plan to get them off again.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 2101302
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101342
36 HP Barrel Shims .020 (4)
Application:Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101482
These covers look good but have a tendency to leak.
Application:Part #: 021109623K
These springs return the valves back to their seats.
Application:Part #: 029198075CH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 029198175
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: n146841
Step stud
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 1198162TS
92mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:
This gasket goes between the valve cover and the head.
