Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. These are Mahle brand. We do not like the wire type of wrist pin keepers and suggest you buy a set of Tru-Arc type keepers. When you get pistons and cylinders, the pistons need to be taken out of the cylinders and have the cosmoline cleaned off and the ring gaps set. Note: The arrows on the pistons go towards the flywheel. If you want your motor to last, I suggest you flip ahead and read BARREL SHIMS.
Bus (Type 2): 2000
No customer reviews for the moment.
Part #: 029198075CH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 2101301
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 2101303
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 021101471
Black Valve Covers
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 039101061D
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 1101383
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101394
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 1101477BL
These covers look good but have a tendency to leak.
Application:Part #: 1198160B
These rings are cast iron.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
