Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the replacement mounting hardware kit for Channel Gasket Style Valve Covers.
These are great valve covers. They're deep enough to accommodate most style rockers. They have a channel style gasket that can be reused. The only problem we've seen is that people tend to over tighten the cover and and that rips the gasket. We run the bolt down until it just hits the cover, then one more turn with the wrench.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 1101477
These covers look good but have a tendency to leak.
Application:Part #: 021101457
These nuts and washers hold the heads on.
Application:Part #: 1101357
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111101481
This gasket goes between the valve cover and the head.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101386
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198092ACH
92mm Pistons & Cylinders set with a 69mm Stroke CHINA
Application:Part #: 1101383
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 1198161
These rings are cast iron.
Application:
This is the replacement mounting hardware kit for Channel Gasket Style Valve Covers.