Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Rings on the pistons are there to eliminate "blow-by".
Rings on the pistons are there to eliminate "blow-by". To see if your cylinders or rings are worn out, take a top ring and place it into the cylinder about an inch down from the top. Using a piston with no rings, push the ring down making sure it is sitting flat in the cylinder. With the ring in the cylinder, use a feeler gauge to measure the ring gap. If it is over .030", either the ring or the cylinder is worn out. If you feel a ridge on the top of the cylinder, then it's a bad cylinder and time for a new set of pistons and cylinders. We prefer using cast rings instead of chrome rings. Chrome rings never seem to seat. This causes a lot of "blow-by". Note: Use ring spreader pliers to put the rings on. When putting the cylinders on, make sure none of the ring gaps are lined up.
Bug (Type 1): 1200
Bus (Type 2): 1200
Ghia: 1200
No customer reviews for the moment.
Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 1107434
Not our favorite type of piston pin keeps.
Application:Part #: 1198092ACH
92mm Pistons & Cylinders set with a 69mm Stroke CHINA
Application:Part #: 1101374
40 HP Barrel Shims .040 (4)
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 021101457
These nuts and washers hold the heads on.
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1109513
Valve seats are used in the big valve heads.
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198090ACH
90.5mm Pistons & Cylinders - 69mm Stroke CHINA
Application:Part #: 1101393
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101355
Here's another long subject, but it'll give you a little something to think about.
Application:
Rings on the pistons are there to eliminate "blow-by".
