Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rings are cast iron.
These rings are cast iron. We prefer them over the chrome rings that come in the above big bore kits. It's true that with chrome rings your barrels won't wear as much, but that's because they never seat. We suggest you take the rings off the piston and give them to your girlfriend for bracelets. They're a cheap gift and she won't be around much longer anyway if you don't stop spending so much time on your motor. Be careful putting the rings on, as they can break. Always use spreader pliers. They are sold in sets.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 311198069FM
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. MAHLE
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198159
These rings are cast iron.
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198092B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1107431
There are two types of keepers we like to use.
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1101482
These covers look good but have a tendency to leak.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:
These rings are cast iron.
