Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 2101303
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N122343
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1101383
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:Part #: 1198090A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101476
These are great valve covers.
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:
