Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These nuts and washers hold the heads on.
These nuts and washers hold the heads on. The washers are thick so they won't deform under heat and torque. The torque on 10mm nuts is 28 ft. lb. and the 8mm nuts is 18 ft.lb. One trick is to use 3M glue on the bottom of the washers in the rocker area to prevent leaking through the head.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1101353
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 311101353A
New single port head.
Application:Part #: 1101394
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101346
36 HP Barrel Shims .060 (4)
Application:Part #: 315198163A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:Part #: 1101468
If you have high compression you will need to vent the valve covers into a breather box.
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 311198069MF
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. MAHLE FORGED
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1107430
There are two types of keepers we like to use.
Application:
These nuts and washers hold the heads on.