Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Bad guides are replaced and new exhaust valves are installed along with a three angle valve job. All heads are bead blasted and measured for cc volume. Flycutting is done if needed. Note: It is better to buy these in pairs so we can match up a pair by cc's. The amount of cc's greatly affects the compression ratio. We do not believe in head shims, but recommend barrel shims to lower the compression ratio. CORES FOR REBUILT HEADS MUST NOT HAVE CRACKS OR WELDS.
Bus (Type 2): 1700
No customer reviews for the moment.
Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1198159
These rings are cast iron.
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:Part #: 2101309
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101355
Here's another long subject, but it'll give you a little something to think about.
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101476
These are great valve covers.
Application:Part #: 1101482EMP
This is the replacement mounting hardware kit for Channel Gasket Style Valve Covers.
Application:Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 113101355A
New dual port head
Application:Part #: 021101481
This gasket goes between the valve cover and the head.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 2101302
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101469
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
Application:Part #: 025101065C
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:
