Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These flywheels have been reconditioned and are sold on an exchange basis.
These flywheels have been reconditioned and are sold on an exchange basis. If your flywheel has a groove where the clutch rides, it's a good idea to replace it. Read CRANKSHAFT ENDPLAY SHIMS for important instructions on flywheel installation.
Bug (Type 1): 40hp-1300
Bus (Type 2): 40hp-1300
Type 3: 40hp-1300
Ghia: 40hp-1300
No customer reviews for the moment.
Part #: 113105209
This is a steel gear that goes on the crank to turn the cam.
Application:Part #: 111105245
This seal goes behind the flywheel.
Application:Part #: JC86050
Jaycee Billet 7" Crank Pulley for Street Cars, Black
Application:Part #: 1105169
These cranks are made from stock German core cranks.
Application:Part #: 111105713A
Rod Bearings .20
Application:Part #: 111105287
Flywheel Shim 25-36HP, .34mm (0.0135")
Application:Part #: 1105169F
Forged 69mm Counter Weighted Crankshaft
Application:Part #: JC86040
Jaycee Billet 7" Crank Pulley for Street Cars, Red
Application:Part #: 1105297
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 1105401A
These connecting rods are longer than stock.
Application:Part #: 111105701A
These are the shells that go in the rods and ride on the crank.
Application:Part #: 1105258
This is a stock, zinc-plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 111105259
The bolt and washer that holds the crankshaft pulley on.
Application:Part #: 1105251CH
This is a stock pulley that has been chromed.
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105273CH
Lightened 12 lb.
Application:
These flywheels have been reconditioned and are sold on an exchange basis.
