Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Generators supply the battery with voltage. To test a 12v generator, take the wires off the D+ and the DF terminals. Grab a volt meter and hook up the volt meter so the positive lead goes to the D+ and the negative to the DF. Now run a jumper wire from the DF to the D-. Start the car and rev the motor. If the meter pegs, the generator is good and if it doesn't, then it's bad. Now if the meter jumps to lower voltage the generator may need to be polorized. To polorize a generator, make sure the voltage regulator wires are still disconnected. Take off the generator belt. Using a battery with jumper cables, hook up the positive to the D+ and the negative to D-. Now with a jumper wire, go from the DF to the body of the generator. Hold the wire there just long enough to see the generator spin like a motor; no longer, or you will burn up the generator. Some generators are sold on exchange.
Bus (Type 2): 68-71
No customer reviews for the moment.
Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: N127051
This is the pulley on the generator that holds the belt.
Application:Part #: 1903109BORD
Billet Pulley Outer Half Red
Application:Part #: GR15X
Generators supply the battery with voltage. Rebuilt + Core
Application:Part #: 111119141A
Cooling Fan Nut
Application:Part #: SR28X
This is what starts the car.
Application:Part #: SR17X
This is what starts the car.
Application:Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: SR11X
This is what starts the car.
Application:Part #: 1903109POL
Polished Billet Alternator/Generator Pulley Kit
Application:Part #: GR11X
Generators supply the battery with voltage.
Application:Part #: 111119270B
This is a hub that is keyed onto the generator or alternator to mount the fan.
Application:Part #: AL82NCH
This unit supplies the battery with voltage.
Application:Part #: 113119031B
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: 1903109BIL
Billet Aluminum Pulley - 12 volt alt/gen
Application:Part #: 30019
This little box tells the generator what to do.
Application: