Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These springs are made for high RPM engines.
These springs are made for high RPM engines. If you plan on revving your engine more then 7k RPMs, use these springs. If you run dual springs, we suggest you run steel push rods. Dual springs are hard on the valve train but is the only way to keep the lifters on the cam at high RPMs.
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1107433
Not our favorite type of piston pin keeps.
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 1198090ACH
90.5mm Pistons & Cylinders - 69mm Stroke CHINA
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101477
These covers look good but have a tendency to leak.
Application:Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198092BWCH
92mm Pistons & Cylinders Thick Wall set with a 82mm Stroke CHINA
Application:Part #: 2109612
35.5mm SS Valves (Set of 4)
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 1198094C
94mm Mahle Barrels
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1107094VP
94mm Wiseco Pistons -- with Valve Pockets
Application:Part #: 070198169
Rings on the pistons are there to eliminate "blow-by".
Application:
These springs are made for high RPM engines.
