Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These mounts should only be used on cars that are not daily drivers.
These mounts should only be used on cars that are not daily drivers. The good thing about them is the trans doesn't move. The bad thing is they are hard on parts and transmit a lot of noise into the car.
No customer reviews for the moment.
Part #: 001301209C
Nose Cone Seal Holder
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 2311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 6301265
Putting a Bus IRS trans into your bug is the way to go, because it comes with a lower ring and pinion stock and is a stronger trans.
Application:Part #: 113311113A
This seal goes around the mainshaft.
Application:Part #: 311301343
Sleeve
Application:Part #: 1301150
Bolt on Center Transmission mount, Urethane stops included
Application:Part #: 1517120
These diffs add two more spider gears to your differential, plus the housing is way stronger then stock.
Application:Part #: 113301185A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 2301241
This steel ball replaces the factory plastic one in Bus trannies 1968-1979.
Application:Part #: 113301265E
These rubber mounts hold the transmission in place.
Application:Part #: 6711174
Aligns Type 1 Shift Shaft to Type 2 Transmission Coupler, Aluminum
Application:Part #: 6301263
These mounts should only be used on cars that are not daily drivers.
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 001301209A
Nose Cone Seal Holder
Application:Part #: 111398005A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:
These mounts should only be used on cars that are not daily drivers.
