Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what starts the car.
This is what starts the car. It usually quits the furthest place from home. To bench test a starter is tough, as they can work but are weak. In other words, it will work on the bench, but as soon as it has the drag of the engine on it, it won't. The way we test starters is in the car with a remote starter button (a push button with two long wires). Disconnect the battery. Hook up one of the wires to the big post that the battery cable is hooked to and the other wire to where the push-on wire is located. Now connect the battery back up and make sure the E-brake is on and the car is out of gear. Push the remote starter button. If the engine turns over the starter is good, and if it doesn't, it's bad. If you find the starter works with the remote starter but not with the key, call us. You might need a hard start relay or a new electrical part in the ignition switch. Some starters are sold on exchange.
Bus (Type 2): 76-83
No customer reviews for the moment.
Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 30091
This little box tells the generator what to do.
Application:Part #: 111903181
Generator Pulley Nut
Application:Part #: SR15HT
This is what starts the car.
Application:Part #: 111119270B
This is a hub that is keyed onto the generator or alternator to mount the fan.
Application:Part #: 111903515A
These are the bearings and brushes for your generator.
Application:Part #: 021903137A
This is the belt that turns the generator.
Application:Part #: 1903141B
This strap is much stronger than the stock strap, not that you need a super strap to hold the alternator or generator.
Application:Part #: 1903109BIL
Billet Aluminum Pulley - 12 volt alt/gen
Application:Part #: 111903137D
This is the belt that turns the generator.
Application:Part #: 1903109POL
Polished Billet Alternator/Generator Pulley Kit
Application:Part #: 211903183
This is the bell shaped spacer that hold the outer half of the generator pulley on.
Application:Part #: SRHT6V
This is what starts the car.
Application:Part #: 1903183
This aftermarket chrome cap nut and spacer hold the alternator/generator pulley on.
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: 043903109GR
This is the pulley on the generator that holds the belt.
Application:
This is what starts the car.
