Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. We do not like the wire type of wrist pin keepers and suggest you buy a set of Tru-Arc type keepers. When you get pistons and cylinders, the pistons need to be taken out of the cylinders and have the cosmoline cleaned off and the ring gaps set. Note: The arrows on the pistons go towards the flywheel. If you want your motor to last, I suggest you flip ahead and read BARREL SHIMS.
Bus (Type 2): 1800
No customer reviews for the moment.
Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 028109453
This screw rides against your valve, opening and closing it.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 039101061D
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:Part #: 1198159
These rings are cast iron.
Application:Part #: 1101477
These covers look good but have a tendency to leak.
Application:Part #: 021198175
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1101462KIT
This kit has the correct nuts and washers to hold the heads on the engine..
Application:Part #: 311198069MF
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. MAHLE FORGED
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 022101361C
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
