Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 2101474
These bolt on valve covers are for the pancake style engine.
Application:Part #: 1107430
There are two types of keepers we like to use.
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101392
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 1101371
40 HP Barrel Shims .010 (4)
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1198160B
These rings are cast iron.
Application:Part #: n146841
Step stud
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 111198157B
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1101391
Whether your motor lives or not can depend upon this little shim.
Application:
