Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Bad guides are replaced and new exhaust valves are installed along with a three angle valve job. All heads are bead blasted and measured for cc volume. Flycutting is done if needed. Note: It is better to buy these in pairs so we can match up a pair by cc's. The amount of cc's greatly affects the compression ratio. We do not believe in head shims, but recommend barrel shims to lower the compression ratio. CORES FOR REBUILT HEADS MUST NOT HAVE CRACKS OR WELDS.
Bus (Type 2): 2.0 Square Port
No customer reviews for the moment.
Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:Part #: 1101386
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 022198075ACH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: 311198169B92
Piston Ring Set 92mm
Application:Part #: 1101476
These are great valve covers.
Application:Part #: n146841
Step stud
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 021101417A02
Exhaust Valve Guide +.002"
Application:Part #: 021198075BCH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 028109453
This screw rides against your valve, opening and closing it.
Application:Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 039101061D
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101355
Here's another long subject, but it'll give you a little something to think about.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
